Applications: Welding Cables are flame retardant, oil resistant, resilient, resists compression cuts and abrasion, durable, and survives rough handling. Designed for use as arc welding leads from the secondary side of the power source, typical of welders and welding generators. Power supply applications not exceeding 600 volt AC. Sizes 1/0 and larger for permanent wiring in conduit or tray of 600 volt power supplies, hoists, cranes, or other applications where flexible power leads must be installed in conduit, raceways or trays. Applications: DLO is especially suitable to supply power to traction motors of diesel-electric locomotives. It is also recommended as a portable cable for drilling rigs, on-shore or off-shore, railroad and transit car wiring, electric earth-moving equipment, in shipyard applications, arc welder supply leads, power and control jumper cable, Telcom power supply and motor leads. The cable is suitable for use in wet or dry areas, conduit, ducts, troughs or trays, and where superior electrical properties are desired. The maximum continuous conductor temperature for normal operation in wet or dry locations is 90°C. DLO resists oils, acids, alkalies, heat, flame, and has abrasion resistance. Specifications: • Made in accordance with ICEA S-75-381 - Portable and Power Feeder Cables for Use in Mines and Similar Locations • MSHA accepted (P-7K-123040) • RoHS Compliant • UL listed as Type RHH-RHW-2 per UL 44 • CSA listed as Type RW90 1kV per C22.2 No 3895 • Low Smoke Rated (LS-UL) • Meets FT-4 and VW-1 Flame Tests